New options
often become available.
Please
contact us if there is an option you would like not listed below.
Please call
for current prices. Unless stated otherwise, all options are available at
extra cost. Some options may require a 60% down payment with the purchase
order, with balance due upon delivery.
-
Touch Probe
allows for measuring material surface off of Z axis with a resolution of
±0.00005 inch. Triggers at each Z axis touch. Requires CamSoft software.
-
Touch-Off Pad
allows the computer to measure the tip of the cutting tool and the tip of
the touch probe for calibration purposes, relative to the material being
cut. Has a resolution of ±0.00005 inch.
-
Motion controller can be
either Ethernet based PC card (standard) or PCI parallel communication
(fastest)
-
Special customer-specified motion control systems
-
Special customer-specified axis motor systems
-
Voltage
220 VAC option (No extra cost)
-
CamSoft CNC software
available at a special S&W only discount!
-
Custom machine axis sizes
available upon request. Minimum extra cost $1,000 for one unit.
-
Machine Base
B
Sturdy steel frame for holding the machine.
-
Precision Motor
Spindle FS33-60. German Engineering. 33mm diameter, speeds to 60,000 rpm. DC
Brushless with hybrid ceramic bearings. Run-out 0.000078" sealed air intake
for dusty and wet environments. Output power is 170 watts. Manual tool change,
collet 1/8" max. Very quiet.
-
Other special spindles available upon
request.
-
Vacuum system available upon request.
-
Machine enclosures available upon request.